Q345E Hydraulic Drilling Mud Centrifuge With ATEX Electrical Control Device

Full Hydraulic Drilling Mud Decanter Centrifuge with ATEX Electrical Control Device

AIPU brand hydraulic drive decanter centrifuge with a well-known hydraulic drive system to meet the needs of domestic and foreign customers. the horizontal screw centrifuge drum and the thruster hydraulic drive system drive the oil pump stroke through two motors to drive the hydraulic motor and hydraulic differential. A fully hydraulically driven centrifuge makes it possible to separate the mud under the high temperature environment. the compact single-turn structure of the full hydraulic decanter makes it earlier to operate and install in the field.

Why do we call centrifuge the 4th solids control equipment or 5th cleaning equipment?

Because it's behind desilter cone or mud cleaner. The middle-speed centrifuge is usually fixed frequency and get rid of 5-7microns cuttings. While the high-speed one is usually VFD and separate 2-5 microns cuttings out of the liquid. 

The material of decanter centrifuge is stainless steel. The minimum grade is S.S304, and then S.S316, S.S316L, Duplex 2205. The screw impeller can be welded or coated with tungsten carbide for better anti-corrosive performance. This will help us to get longer service life and save time to maintain or repair

Besides cuttings separation in drilling mud, the centrifuge is also used to recycle some barite. And decanter centrifuge is widely used in waste management, oil sludge treatment more and more.

Your Advantages In Processing Drilling Mud and Emulsions:

• Reduction in disposal costs
• Reduction in the quantity of sludge in the closed system
• Cost-saving of up to 60% for maintenance and upkeep
• Reduction in wear, especially on the slurry pump and drill bit
• Extended sludge service life

Decanter centrifuge is also referred to as centrifuge decanter, decanting centrifuge.

In oil and gas drilling, we call then solids control centrifuge or drilling fluids centrifuges. Drilling mud is pumped into centrifuge by screw pump or submersible slurry pump. The treating capacity is from 40-65m³/h. Higher speed centrifuge process less drilling fluids or produce fewer particles. However, higher speed centrifuge separates finer solids out of drilling mud. Centrifuge mud source is in the desilter tank/compartment.

The decanter centrifuge bowl size is ranged from 450x1000mm to 530x1320mm. Different size drums will produce a different flow rate. Of course, the speed is not the same on all centrifuge.

Worldwide, a hundred decanters are already in use in the drilling slurry industry. Aipu solids control has a broad range of experience and numerous references that offer you decisive advantages:

• Decanters specially adapted to the drilling slurry, with special wear protection
• Production of the decanters exclusively in Germany, with high-quality materials and trained specialists
• Many years of experience and relevant specialist knowledge in the use of decanters for processing drilling slurry, drilling emulsions and drilling muds
• Inexpensive, worldwide aftersales service and a comparatively low amount of maintenance work
• Personal support, on-site service and project planning individually tailored to your requirements

Please check below technical specifications on APLW centrifuge for your reference.

For any interest or demand, please feel free to contact AIPU. You will get a free offer on the optimal solution, you will get a professional proposal very soon.